The basic camouflage pattern is Castellan green airbrushed over a black primer, the model is then masked with normal masking tape taking care to ensure the paint underneath has cured completely (otherwise the tape can lift the paint, although sometimes this can make for a neat paint peeling effect). The camo pattern is then completed with P3 Hammerfall Khaki. Once the masking tape is removed I weather the vehicle with Agrax Earthshade and also an oil paint wash made from Burnt Umber and white spirit, although I am tending toward the GW wash as it is less smelly and alsmost as good in this application. Paint chips are sponged on where damage might occur, then edge highlights are applied using Gretchin green and Kommando Khaki to help the model pop on the gaming table. Transfers are applied over a gloss varnish, and when they are dry I distress them with the end of a needle file or scalpel, if i didn't do this the transfers would look far too fresh compared to the rest of the vehicle. Details are then added- lenses, skulls etcetera. If the vehicle has a name plate I write this in using a 0.25mm Rotring Isograph technical pen with indian ink, my hand isn't all that steasy but the results look okay. My two Manticores are named 'Inductor' and 'Perditrix' which translate loosely as 'Persuader' and 'Destroyer'
To finish the model is given a coat of Vallejo Matt Polyurethane Varnish, which is probably the best varnish I've used so far. All of the vehicles are fully magentised with swappable weapons, it's also nice to remove to remove the manticore Missiles as there are used in a game, it beats counting!
0 Yorumlar